1. Operating procedures Specific instructions are given to all operators engaged in machining to ensure the quality of each machine.
2. Scope of application: Detailed description of the specific operation of mechanical processing personnel (including car, milling, drilling, planing, grinding, shearing, etc.) during work.
3. The safety operation procedures of the machine shop shall make detailed and detailed instructions for all operators engaged in machining to ensure the quality of each machine.
4. It describes in detail the specific operation of mechanical processing personnel (including car, milling, drilling, planing, grinding, shearing, etc.) during work.
5. Mechanical processing must be carried out in accordance with this regulation during the processing of various parts.
4 implementation steps
Operators engaged in all kinds of machinery must undergo safety technical training and pass the examination before they can work.
Before use, strictly use protective equipment according to regulations, tie the cuffs, not to wear scarves and gloves, and women workers should be in the hat. The operator must stand on the pedals.
2 Respond to all parts of the bolts, travel limit, signal, safety protection (insurance) device and mechanical transmission parts, electrical parts, and each lubrication point to be strictly checked before it can be activated.
The safety voltage and voltage of various types of machine tool lighting applications shall not exceed 36 volts.
Work, clamps, tools and workpieces must be securely clamped. All kinds of machine tools should be idling at low speed after driving. After everything is normal, they can be officially operated.
It is forbidden to put tools and other things on the machine rail surface and on the workbench. Do not remove iron filings by hand. Use special tools to clean.
Before the machine is started, observe the surrounding dynamics. After the machine is started, it should stand in a safe position to avoid the movement of the machine and the splash of iron filings.
During the operation of various types of machine tools, it is not allowed to adjust the shifting mechanism or stroke. Do not touch the working parts of the transmission part, moving workpieces, tools, etc. in the hand. It is not allowed to measure any size during operation. It is forbidden to pass the machine transmission part. Transfer or take items such as tools.
If abnormal noise is found, it should be stopped and repaired immediately, and it must not be forced or operated. The machine tool is not allowed to be overloaded.
During the processing of each machine part, the process discipline is strictly enforced, the drawings are clearly seen, the technical requirements of each part of the control points, roughness and related parts are clearly seen, and the processing steps of the production parts are determined.
Adjust the machine speed, stroke, clamping workpieces and tools, and stop when wiping the machine. It is not allowed to leave the job while the machine is running, so it is necessary to stop and cut off the power when leaving.
The raw materials to be processed and the finished products, semi-finished products and scraps to be processed must be stacked at the designated place, and all tools and tools must be kept intact and good.
